Used 8" Testing Table for Wilson Rockwell Hardness Testers. This Flat, 203mm / 8in Diameter testing table is a popular work support for large test specimens. When the table, which screws on to the elevating screw, is being used, the vertical capacity is reduced by about 1"/25mm. This table fits most standard Wilson Rockwell Hardness testers as well as M, MJ & L Brinell hardness testers built since 1976. There may be indenter marks and slight scratches on the surface which is typical of used anvil/tables. The surface will be lightly honed to remove any high spots.
Diamond Spot Anvil with a 3/4" shank for hardness testing. Made in USA. The Diamond Spot Anvil is recommended for supporting thin, soft sheet metal. The center of the anvil has a flat polished diamond surface(9.5mm / 3/8in). As the sample deforms under test the load, this surface standardizes the frictional effect between the anvil and sheet metal. The diamond Spot anvil should only be used with a ball indenter on the Superficial rockwell scale. The Diamond Spot anvil must NOT be used with diamond indenters.
Used Gooseneck Anvil, in like new condition, for Wilson Rockwell Hardness Testers and other testers with the same Acme thread and 3/4" ID. This anvil comes complete with a 1/4" replaceable anvil, gooseneck body and nut. Other anvils diameters are available. Let us know what size you need. The tester in the picture is not included.
Raised Shallow "V" anvil with a 3/4" shank for hardness testing. Made in USA. The Raised Shallow Vee Pedestal Anvil 9.5mm / 3/8in Diameter x 25mm / 1 in high is used for cylindrical shaped rods or tubing up to 1/4" 6.3mm diameter.
Standard "V" anvil with a 3/4" shank for hardness testing. Made in USA. The standard Vee anvil is used for cylindrical shaped rods or tubing .25" (6mm) or larger in diameter.
Sign In
