Loading... Please wait...
Welcome

Our Newsletter


Sort by:

Anvils

anvils4.png

Full selection of anvils for your hardness tester.

For millimeter shanks, please call.

  • Anvil: 1-1/2" Flat Anvil
    $112.00 Anvil: 1-1/2" Flat Anvil
    1-1/2" diameter flat anvil with a 3/4" shank for hardness testing. Made in USA.  

  • Anvil: 1/2" Pedestal Spot Anvil
    $125.00 Anvil: 1/2" Pedestal Spot Anvil
    1/2" diameter Spot anvil with a 1" projection and a 3/4" shank. Made in USA. (Note: picture is of a 1/4" Spot Anvil)  

  • Anvil: 1/4" Pedestal Spot Anvil
    $125.00 Anvil: 1/4" Pedestal Spot Anvil
    1/4" diameter Spot anvil with a 1" projection and a 3/4" shank. Made in USA.  

  • Anvil: 2-1/2" Flat Anvil
    $135.00 Anvil: 2-1/2" Flat Anvil
    2-1/2" diameter flat anvil with a 3/4" shank for hardness testing. Made in USA.  

  • Anvil: 8" Testing Table Used
    Anvil: 8" Testing Table Used
     Used 8" Testing Table for Wilson Rockwell Hardness Testers. This Flat, 203mm / 8in Diameter testing table is a popular work support for large test specimens. When the table, which screws on to the elevating screw,...

  • Anvil: Diamond Spot Anvil
    Diamond Spot Anvil with a 3/4" shank for hardness testing. Made in USA. The Diamond Spot Anvil is recommended for supporting thin, soft sheet metal. The center of the anvil has a flat polished diamond surface(9.5mm / 3/8in)...

  • Anvil: Gooseneck Anvil
    $650.00 Anvil: Gooseneck Anvil
     Used Gooseneck Anvil, in like new condition, for Wilson Rockwell Hardness Testers and other testers with the same Acme thread and 3/4" ID. This anvil comes complete with a 1/4" replaceable...

  • Anvil: Raised Shallow V Anvil
    $125.00 Anvil: Raised Shallow V Anvil
    Raised Shallow "V" anvil with a 3/4" shank for hardness testing. Made in USA. The Raised Shallow Vee Pedestal Anvil 3/8" Diameter x 1"in high is used for cylindrical shaped rods or thick wall tubing up to 1/4" (6...

  • Anvil: Standard V Anvil
    $158.00 Anvil: Standard V Anvil
    Standard "V" anvil with a 1-1/2" body diameter and a 3/4" shank for hardness testing. Made in USA.The standard Vee anvil is used for cylindrical shaped rods or thick wall tubing that is 1/4" (6mm) or larger in...